Patton electronic T1/E1 CHANNELIZED GIGABIT ROUTER 2884 - Manual (Page 25)

Installing the OnSite 2884 25
OnSite Model 2884 User Manual 3 • OnSite installation
Connecting the power supply
The 2884 has the option of an internal or external
Internal AC Power Supply , or an internal or external Exter-
nal DC Power Supply .
Internal AC Power Supply.
1. Insert the female end of the AC power to the mains port.
Figure 5. 2884 rear panel
2. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to “Contacting Patton for assistance” on page 32 to find out how to replace it with a compatible
power cord.
3. Connect the male end of the AC power cord to an appropriate AC power outlet.
Figure 6. Power LED
4. Verify that the green Power LED is lit (see figure 6 ).
• Do not connect power to the AC Mains at this time.
• There are no user-serviceable parts in the power supply sec
tion of the Model 2884. Contact Patton Electronics Technical
support at (301)975-1007, via our web site at
http://www.patton.com, or by e-mail at [email protected],
for more information.
• The internal power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
WARNING
RS-232
Console
ETH 1
ETH 0
Reset
3
2
1
0
T1/E1
Power
(~120–240V, 50/60 Hz, 1A)
T1/E1
Ports 0-3
Console
RS-232 port
ETH 0
10/100/1000Base-T port
ETH 1
10/100/1000Base-T port
RESET
button
120-240V
, 50/60 Hz, 1A
Power
Power
Port 1 Port 0
Model 2884 IpLink
T1/E1 Channelized Gigabit Router