Patton electronic T1/E1 CHANNELIZED GIGABIT ROUTER 2884 - Manual (Page 17)

Rear and Front Panels 17
OnSite Model 2884 User Manual 1 • General information
Table 3. Rear panel ports
Port Description
LAN ETH 0 Auto-MDX Gigabit-Ethernet port, RJ-45, connects the unit to an Ethernet WAN device
(for example, a cable modem or fiber modem). Note: Only full duplex modes are
supported.
LAN ETH 1 Auto-MDX Gigabit-Ethernet port, RJ-45, connect the unit to an Ethernet LAN (for
example, a PC, printer, or wireless bridge). Note: Only full duplex modes are sup-
ported.
T1/E1 0 RJ-45 connector providing E1 (2.048Mbps) or T1(1.533 Mbps) T1/E1 interface,
meeting all requirements of ITU-T recommendations for G.703. Use a shielded E1 or
T1 interface cable for 120 Ohm balanced connections to connect the OnSite with
an NT or ET, e.g. a PBX or LE.
T1/E1 1 RJ-45 connector providing E1 (2.048Mbps) or T1(1.533 Mbps) T1/E1 interface,
meeting all requirements of ITU-T recommendations for G.703. Use a shielded E1 or
T1 interface cable for 120 Ohm balanced connections to connect the OnSite with
an NT or ET, e.g. a PBX or LE.
T1/E1 2 RJ-45 connector providing E1 (2.048Mbps) or T1(1.533 Mbps) T1/E1 interface,
meeting all requirements of ITU-T recommendations for G.703. Use a shielded E1 or
T1 interface cable for 120 Ohm balanced connections to connect the OnSite with
an NT or ET, e.g. a PBX or LE.
T1/E1 3 RJ-45 connector providing E1 (2.048Mbps) or T1(1.533 Mbps) T1/E1 interface,
meeting all requirements of ITU-T recommendations for G.703. Use a shielded E1 or
T1 interface cable for 120 Ohm balanced connections to connect the OnSite with
an NT or ET, e.g. a PBX or LE.
Console Used for service and maintenance, the Console port, an RS-232 RJ-45 connector,
connects the product to a serial terminal such as a PC or ASCII terminal (also called
a dumb terminal).
100-240 VAC 50-
60 Hz Electricity supply socket for mains power cable.