Planet Technology VIP-320 - Manual (Page 45)

become annulment!
2. Press button to show [EW361001] (Firmware)
This setting is to show the base firmware version.
Press * button and the display will show DEFAULT N
default
Press and button to switch to DEFAULT Y reload factory
Time for reload factory default is 2 seconds then will display OK
This setting use to reset default factory default.
Press * button to switch to PROTECT Y
default
Press and button to switch to DEFAULT Y
This is used for system protection.
Please DO NOT change factory default value, the DCT-100 may
become annulment!
3. Press button to select [F TM 600?] and setting Flash time
During the call, press button can switch to another call.
Press and button to change to F TM 130 (ms)
Press and button to change to F TM 260 (ms)
Press and button to change to F TM 390 (ms)
Press and button to change to F TM 600 (ms)
default
This setting is setting for different flash time.
4. Press button to select [Line out 123]
Press to switch Line out 123 or Line in 123
Press / / and button to enable or disable Line 123
Line out 123
default
Line in 123 default
This setting is setting Line-in/Line-out.
Please DO NOT change factory default value, the DCT-100 may
become annulment!
5. Press button to delete subscriber (handset) mode
Press the handset number and button to de-register this handset.
This setting is using for de-register subscriber (handset).
EW3TIJ05
DEFAULT N
PROTECT Y
F TM 600 ?
Line out 123
H DeSub ?
45