Planet Technology VIP-320 - Manual (Page 12)

12
• Select the desired DECT base (Base1 for example). Press INT key, DCT-100 will display Searching:
on the LCD screen
• Wait till a machine hardware ID shows up, ex: 002F5-11708H, then press INT
• When machine prompts for PIN number, inert PIN number 1590 then press INT, then DCT-100 will
start to register to base and showing Searching….
• Once the registration is completed, the DCT-100 will show HS x, Base y on the screen.
Note: x is the registered handset number and y is the registered DECT base.
Un-register / Reset your DCT-100
• Press the INT button before power on the handset.
• Power on the handset, and DO NOT release the INT button till the LCD displays "F->clear
Subs"
• Press the down button to clear the handset settings.
• Power off, power on handset again, the handset will display "Not Sub", and it is now not registering
to any DECT base.