Pella 80WX0101 - Manual (Page 7)

INSTALLING ROTO COVER AND CRANK
Note: Finish the interior of the window and allow the window to dry before
proceeding with these instructions. (To open the window for finishing, partially
insert the lock handle into the jamb, unlock the unit, temporarily attach the crank
handle and turn to open.)
A. Place the cover over the operator stud and
snap into place. Position the pocket end of the
cover into place.
Note: If the cover does not have the screw
hole, apply pressure on the pocket end of
the cover to snap the cover into place and
proceed to step C.
B. Insert the provided screw into the hole in
the bottom of the pocket. Use a # 1 Phillips
screwdriver to secure the pocket screw snug
against the bottom of the pocket to avoid
scratching the crank handle knob. DO NOT
over tighten.
Pocket End
Operator Stud
Screw Hole
A
B
Crank Handle
Operator Stud
Set Screw C
D
Knob
Pocket
E
C. Use a medium size flat-blade screwdriver to
loosen the set screw in the crank handle.
D. Slide the crank handle onto the stud. Unlock,
open window, then close and lock window.
E. Fold the crank handle down and check
alignment of knob with the pocket.
Note: You may need to adjust the crank
position on the stud until the correct
alignment is achieved.
F. Open the crank and tighten the set screw.
G. After the final installation, fold the crank over
and snap the knob into the pocket.
Note: Even with the window open the crank
can be folded to avoid interferring with the
window treatments.