Panasonic SC-AK450 - Manual (Page 11)

11
RQT8043
RQTV0191
LANG - 5
LANG - 4
FRANÇAIS
DANSK
ENGLISH
FM/AM radio
TUNER /
BAND
Manual tuning Manual tuning
1 Press [TUNER/BAND] to select “FM” or “AM”.
2 Press [PLAY MODE] to select “MANUAL”.
3 Press [
4, REW/ ] or [¢, / FF] to select the
frequency of the required station.
“ ” is displayed when a stereo FM broadcast is being
received.
To tune automatically
Press and hold [
4, REW/ ] or [¢, / FF] until the
frequency starts changing rapidly. The unit begins auto
tuning, stopping when it fi nds a station.
• Auto tuning may be interrupted when there is excessive
interference.
• To cancel auto tuning, press [ 4, REW/ ] or
[ ¢, / FF ] once again.
To improve FM sound quality
Press and hold [PLAY MODE] to display “MONO”.
To cancel
Press and hold [PLAY MODE] again until “MONO”
disappears.
• MONO is also canceled if the frequency is changed.
• Turn off “MONO” for normal listening.
FM allocation setting
TUNER
FM/AM/XM
By main unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
To change the step to 0.1 MHz
1 Press and hold [TUNER, FM/AM/XM] when “FM” is
selected.
After a few seconds the display changes to a fl ashing
display of the current minimum frequency.
2 Continue to hold down [TUNER, FM/AM/XM].
• When the minimum frequency changes, release
the button. To return to the original step, repeat the
above steps.
• After changing the setting, previously preset
frequency will be cleared.
TUNER /
BAND
Memory preset Memory preset
20 FM and 15 AM stations can be preset.
Preparation
Press [TUNER/BAND] to select “FM” or “AM”.
Automatic presetting
1 Tune to the frequency where presetting is to begin.
2 Press and hold [PROGRAM] to start presetting.
The tuner presets all the stations it can receive into the
channels in ascending order. When fi nished, the last station
memorized is tuned in.
Manual presetting
1 Press [PLAY MODE] to select “MANUAL”.
2 Press [ 4, REW/ ] or [¢, / FF ] to tune to the
required station.
3 Press [PROGRAM].
4 Press the numeric buttons to select a channel.
For channels 10 to 20 press [
h10], then the two digits.
The station occupying a channel is erased if another
station is preset to that channel.
Selecting a preset station
Press the numeric buttons to select the channel.
OR
1 Press [PLAY MODE] to select “PRESET”.
2 Press [ 4, REW/ ] or [¢, / FF ] to select the
channel.
RQTV0191-P_1EN.indd 11 RQTV0191-P_1EN.indd 11 2/16/07 10:25:51 AM 2/16/07 10:25:51 AM