Pentax L - Manual (Page 191)

189
6
Appe
ndix
In rare cases, the camera may not operate correctly due to static
electricity. This can be remedied by taking the batteries out and putting
them back in again. When the mirror remains in the up position, take the
batteries out and put them back in again. Then, turn the power on. The
mirror will retract. After the procedure is done, if the camera operates
correctly, it does not require any repairs.
* Refer to p.13 of the “PENTAX PHOTO Browser 2.1/PENTAX PHOTO
Laboratory 2.1 Operating Manual” for details on connecting the camera to a PC.
The Autofocus
does not work
The focus mode is
set to \.
Set the focus mode lever to =. (p.118)
The focus mode is
set to k
(Continuous mode).
Set the focus mode to l (Single
mode). (p.122)
The capture mode
is set to \ (Moving
Object) mode.
Set the capture mode to setting other than
\ (Moving Object) mode. (p.47)
AE lock
function does
not operate
AE lock is not
available when set
to a (manual) mode
or p (bulb) mode
Use AE lock with any setting other than a
(manual) mode or p (bulb) mode.
Flash does not
discharge
When flash mode is
set to [Auto
discharge] or [Auto
flash+Redeye
reduct], the flash will
not discharge when
the subject is bright.
Set flash mode to [Manual discharge] or
[Manl flash+Redeye reduct]. (p.49)
Mode dial is set to
[Flash OFF] Set mode dial to any setting other than
[Flash OFF]. (p.47)
The power
zoom system
does not
function
The camera does
not have the power
zoom function.
Use manual zoom. (p.48)
USB
connection with
computer does
not work
properly*
The transfer mode
is set to [PictBridge].
Set transfer mode to [PC].
An error occurred
while sending USB
data.
Change the transfer mode to [PC-F].
USB
connection with
printer does not
work properly
The transfer mode
is set to [PC] or
[PC-F].
Set transfer mode to [PictBridge]. (p.84)
Problem Cause Remedy