Philips FW-V39 - Manual (Page 27)

3139 116 19982
27
English
TROUBLESHOOTING
Warning! Under no circumstances
should you try to repair the set
yourself as this will invalidate the
guarantee. Do not open the set as
there is a risk of electric shock.
• If a fault occurs, check the points listed
below before taking the system for
repair.
• Should any problems persist after you
have made these checks, consult your
nearest dealer or service center.
Disc Player Operation
“ UNREADABLE DISC” is displayed.
• The disc is inserted upside down.
™ Place disc with printed side up.
• Moisture condensation at the lens.
™ Wait until lens has adjusted to normal
room temperature.
• The disc is dirty, badly scratched or
warped.
™ Clean or replace the disc.
• The disc lens is dirty or dusty
™ See section under Maintenance (page
25).
• A CD-RW disc or an incorrect MP3-CD
format disc is inserted.
™ Replace a readable disc or correct
recorded format MP3-CD.
“ NO DISC” is displayed.
• There is no disc in the disc tray.
™ Insert a disc.
No picture on TV screen.
• The video cable is not connected
™ Connect the cable between the system
and TV.
No colour on TV.
• The system switch is not correct.
™ Change the system to respective setting
(PAL or NTSC).
Cannot adjust the TV system to PAL or
NTSC.
• There is a MP3-CD in disc tray 1.
™ Remove the MP3-CD from disc tray 1 or
press DISC CHANGE to select a non-
MP3 disc tray before adjusting the TV
system.
Radio Reception
Poor radio reception.
• The signal is too weak.
™ Adjust the antenna.
™ Connect an external antenna for better
reception.
• The TV or VCR is too close to the stereo
system.
™ Separate the stereo system from the TV
or VCR.
Cannot tune to station
• Wrong tuning grid.
™ Switch to the correct tuning grid.
Tape Deck Operation
“ RECORDING ACTIVE” is displayed.
• A recording is in progress.
™ Stop the recording or wait until it is
finished.
“ TAPE DUBBING ONLY” is
displayed.
• Tape dubbing is only possible in tape
mode.
™ Switch source to tape mode.
Recording or playback cannot be
made or there is a decrease in audio
level.
• Dirty tape heads, capstans or pressure
rollers.
™ See section on tape deck maintenance
(page 25).
• Magnetic build-up in the record/
playback head.
™ Use demagnetizing tape.
Tape deck door cannot open.
• Power failure or AC power plug
disconnect from the wall outlet during
tape playback.
™ Reconnect the AC power plug and
switch on the system again.
pg 01-28/V39/21-En 6/8/01, 9:02 AM 27