Philips FW-V39 - Manual (Page 15)

3139 116 19982
15
English
Programming Tracks
Programming tracks of a loaded disc is
possible when playback is stopped. The
display will indicate the total tracks stored
in the program. Up to 99 tracks can be
stored in the memory in any order
(except
for MP3-CD). When 99 tracks are stored
and you attempt to store another track, the
display will show “
PROGRAM FULL”.
Note:
– Program cannot be used for VCDs when
PBC is switched on. Switch off PBC
before storing tracks from such a VCD.
1 Load the desired discs in the disc trays.
2 Press the VCD (CD 1•2•3) button to
select the disc tray.
™ Programming can only be done on the
selected disc.
3 Press PROGRAM to start programming.
™ The PROG flag starts flashing.
™ It will cancel any previously
programmed tracks and selected
repeat mode.
4 Pressí or ë (or digit 0-9 on the
remote control) to select the desired
track.
• For MP3-CD, press ALBUM - - - - -/+ + + + +
and TITLE - - - - -/+ + + + + to select the
desired Album and Title for
programming.
5 Press PROGRAM to store the track.
• Repeat steps
4 to 5 to store other
tracks.
6 Press Ç once to end programming.
™ The total number of tracks
programmed and total playing time
appear on the display.
Notes:
– For MP3-CD, total playing time will not
be shown.
– If the total playing time is more than
“ 99:59” then “--:--” appears on the
display instead of the total playing time.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Reviewing the program
Reviewing of program is possible only
when playback is stopped.
1 Press í or ë repeatedly to review
the programmed tracks.
2 Press Ç to exit review mode.
CD / VCD / MP3-CD
Playing the program
1 Press PLAYÉÅ to start program
playback.
™ "PLAY PROGRAM" will be
displayed.
™ The track number and elapsed
playing time of the current track will
appear on the display.
• If you press REPEAT during program
playback, all programmed tracks will be
played repeatedly.
™ "REPEAT TRACK", "REPEAT
PROGRAM" or "REPEAT OFF" will
be displayed.
™ The REPEAT and PROG flags appear
on the display.
2 Press Ç to stop program playback.
Note:
– If you press any other DISC DIRECT
PLAY buttons, the system will play the
selected disc or track and the stored
program will be cleared.
Erasing the program (when
playback is stopped)
• Press Ç.
™ “PROGRAM CLEARED” will be
displayed.
Note:
– The program will be erased when the
system is disconnected from the power
supply. The system is switched to
standby mode when you change source
or when you change the program disc.
Repeat (only on remote control)
You can play the current track or the
current disc repeatedly during playback.
1 Press REPEAT on the remote control to
select the various repeat modes.
™ "REPEAT TRACK", "REPEAT
DISC"or "REPEAT OFF" will be
displayed.
™ The REPEAT flag appears on the
display.
• The current track or disc will now be
played repeatedly until you pressÇ.
2 Press REPEAT until the " REPEAT
OFF" mode is displayed to resume
normal playback.
™ The REPEAT flag disappears from
the display.
pg 01-28/V39/21-En 6/8/01, 9:01 AM 15