Philips FW-V39 - Manual (Page 23)

3139 116 19982
23
English
RECORDING
Notes:
– If you do not intend to record via the
microphone, unplug the microphone to
avoid accidental mixing with other
recording source.
– For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr02).
– The tape is secured at both ends with
leader tape. At the beginning and end
of tape, nothing will be recorded for six
to seven seconds.
– The recording level is set automatically,
regardless of the position of VOLUME,
Incredible Surround, DSC or VEC.
– To prevent accidental recording, break
out the tab on the left shoulder of the
tape side that you want to protect.
– If " CHECK TAPE" is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Cr02 tape
detection hole when covering the tab
opening.
Recording the mixed sound /
One Touch Recording
• During microphone mixing, you can
record the mixed sound on a tape in
tape deck 2 except dubbing mode.
• For One Touch Recording, as soon as you
press RECORD, the current source (VCD,
TUNER or AUX) will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2 Press RECORD to start recording.
™ The REC flag starts flashing.
3 Press Ç to stop recording.
Note:
– When you press RECORD while in TAPE
mode, " SELECT SOURCE" will be
displayed. One Touch Recording is not
possible in TAPE mode.
Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press VCD, TUNER or AUX.
• Start playback of the selected source.
4 Press RECORD to start recording.
™ The REC flag starts flashing.
5 Press Ç to stop recording.
Note:
– During recording, it is not possible to
listen to another source.
Dubbing tapes (from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck 2
with full spool to the left.
3 Press DUBBING.
™ "DUB" with "2" scrolling right will be
displayed.
• Dubbing will start immediately.
™ The REC flag starts flashing.
4 Press Ç to stop dubbing.
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– You can listen to other source while
dubbing.
VCD/CD Synchro Start
Recording
1 Load a blank tape into tape deck 2 and a
disc into a disc tray.
2 Press VCD to select VCD/CD mode.
• You can program the tracks in the order
you want them to be recorded (see
Programming Tracks). If not, select the
disc by pressing VCD (CD 1•2•3) and
the tracks are recorded according to the
order on the selected disc.
3 Press RECORD to start recording.
™ The REC flag starts flashing.
• Disc will start playback automatically.
4 Press Ç to stop recording.
pg 01-28/V39/21-En 6/8/01, 9:01 AM 23