Polaris 600RR - Manual (Page 45)

42
THE PERFECT FIT
Accessories
CAUTION
Aggressive studding patterns may require grinding protruding stud bolts
flush to prevent idler wheel damage. Maintain track tension on studded
tracks on the tight side of the spec to prevent heat exchanger damage.
Center of stud must be at least 1 1/8″ (2.86 cm) from outside edge of the
track.
CAUTION
If traction products are added to the track, wear strips must be installed in
the tunnel to avoid excessive wear.
Never add shims to the wear strip. Track damage will result because of
lack of clearance between upper carrier wheels and track.
Use of studs longer than the recommended length on machines
equipped with center coolers will result in center cooler damage or
damage to the tunnel.
Use only Polaris traction products on your snowmobile. Track
warranties are void if track damage or failure results from improper or
excessive stud installation or the use of non-Polaris traction products.
WARNING
Loss of control can result in serious personal injury or death. Proper
balance of traction products on the skis and track must be maintained to
obtain proper vehicle control on hard-packed snow or ice. See your
dealer for assistance.