Svp-ii mode, Phones per access point, 11 rate – Polycom SVP010 User Manual
Page 30
SpectraLink 8000 SVP Server: Administration Guide for Mitel and Cisco
PN: 1725-36031-001_H.doc
30
SVP-II Mode
Defaults to
NetLink IP
for an IP environment. Press Enter to select and
the screen is immediately redrawn with additional options for the IP
environment.
The following options must be configured:
Phones per Access Point
AP specifications are detailed in the Configuration Notes for each brand
and type. Refer to these notes when entering the number of
simultaneous calls supported for your type.
802.11 Rate
Select 1MB/2MB to limit the transmission rate between the wireless
telephones and APs. Select
Automatic
to allow the wireless telephone
to determine its rate (up to 11 Mb/s).
This manual is related to the following products: