Panasonic AJ-HD3700BPE - Manual (Page 155)

– 155 –
RF TEST menu
∑ Error rate display
The error rates (error occurrence rates) are indicated on the 1) TOTAL ERROR and 2) INNER ERROR
displays.
1) TOTAL ERROR
During recording, the error rate of the simultaneous playback
signals is displayed. During playback, the error rate of the play-
back signals is displayed. The audio channels are switched
using the center cursor key.
2) INNER ERROR
The error rates after the inner errors have been corrected are
displayed for the 8 heads.
Proceed as follows to switch between VIDEO & AUDIO and
AUDIO.
1. Press the center cursor key to display the cursor.
2. Press the F key and cursor key ( 2 or 1 ) together to move
the cursor to INNER ERROR.
3. Press the center cursor key to select VIDEO & AUDIO or
AUDIO.
4. Press the ENT key to enter the selection.
∑ Correction and revision statuses
≥ Press the F key and cursor key together to move the highlighted portion from the error rate display
described above.
≥ By aligning the cursor with CONCEAL V or A, with OUTER V or A, or with INNER and then pressing the
center cursor key, it is possible to switch between ON and OFF.
≥ These settings are forcibly set to ON when the test menu is exited. Do NOT turn them OFF since doing so
will cause noise to be generated in the playback picture and sound.
TOTAL ERROR
VIDEO A AUDIO
OUTER CH1
INNER ERROR
VIDEO & AUDIO
5
4
3
2
1
5
4
3
2
1
5
4
3
2
1
B A B A B A
CH0 CH1 CH2 CH3
B