Polaris Phoenix 9921841 - Manual (Page 34)

31
FEATURES AND CONTROLS
Automatic Transmission Gear Selector
The transmission gear selector is located
on the right side of the vehicle.
F: Forward Gear
N: Neutral
R: Reverse
To shift gears, brake to a complete stop.
When the engine is idling, move the
lever to the desired gear.
NOTICE: Shifting gears with the engine speed above idle or while the vehicle is
moving could cause transmission damage.
Whenever the ATV is left unattended, always place the transmission in
gear and lock the parking brake.
Indicator Lights
Indicator lights on the handlebar
console illuminate when neutral
or reverse gears are selected.
The neutral indicator is green.
The reverse indicator is amber.
Kick-Start Lever
If the battery is too weak to start the engine, use the kick-start lever to
start the engine until the battery is serviced.
1. Position the vehicle on a level surface. Lock the parking brake.
Place the transmission in neutral.
2. Fold out the kick-start lever on the left side of the ATV.
3. Make sure the stop switch and main key switch are on.
4. Place your foot on the kick-start. Thrust your heel downward to
crank the engine.
5. If the engine is cold, use the choke as outlined on page 36.
6. After the engine has started, fold the kick-start lever back into place.
Tip: A 10/12 mm wrench is provided in the tool kit for removing or installing the
lever. If not installed, make sure the rubber cap is installed on the kick-start
shaft to protect the rider. Store the kick-start lever under the seat in the rear
cab when not installed.
Gear
Selector
Reverse
Neutral