Panasonic AW-E800 - Manual (Page 28)

-26-
● COLOR PHASE ADJUSTMENT
Supply the output signal (split color bar) from the color
special effect generator to a color monitor or vec-
torscope. Adjust the color phase of the camera.
[ADJUSTMENT with RCU (RCB, Hybrid control panel)]
Use the subcarrier phase coarse adjustment control
and subcarrier phase fine control.
* It is recommended that a vectorscope be used for
maximum accuracy in color phase adjustment.
[ADJUSTMENT by CAMERA]
1. Press the NO/BAR switch for over 5 seconds for the
color bar mode.
2. Select [G/L Adjustment] on the main menu, then
select [SC Coarse] on the sub menu.
3. Make coarse adjustment with the YES/ABC switch
and the NO/BAR switch.
4. Select [SC Fine] on the sub menu. Perform fine
adjustment with the YES/ABC switch and the
NO/BAR switch.
Magenta Green Cyan Yellow White Red Blue Black
Magenta Green Cyan Yellow White Red Blue
Color bar of
camera
Color bar of special
effects generator
**G/L, @ Color Bar Set**
H Phase
±
0
SC Coarse 1
SC Fine
±
0
Color Bar Set 7.5IRE
Return
Sprit line