Panasonic RQT9633-4P - Manual (Page 12)

12
RQT9633
Others
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select
“AUTO OFF” and then press [OK].
2
Press [3, 4] to select “OFF” and then press
[OK].
≥ To turn automatic standby on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.
The brightness of this unit’s display can be
changed.
1
Press [SETUP] repeatedly to select “DIMMER”
and then press [OK].
2
Press [3, 4] to select “ON” and then press
[OK].
To cancel the dimmer, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [CD] to select “CD”.
2
Press and hold [CD] on the main unit and [3]
on the remote control until the main unit’s
display shows “REMOTE 2”.
3
Press and hold [OK] and [3] on the remote
control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the
steps above by replacing [3] with [4].
Troubleshooting
Before requesting service, make the following
checks. If you are in doubt about some of the check
points, or if the solutions indicated in the following
guide do not solve the problem, refer to “Customer
Services Directory (United States and Puerto Rico)”
on page 19.
Humming heard during play.
≥ An AC power supply cord or fluorescent light is near the
cords. Keep other appliances and cords away from this
unit’s cables.
Incorrect display or play will not start.
≥ Make sure that the disc is compatible with this unit. (> 4)
≥ There is moisture on the lens. Wait for about an hour
and then try again.
A beat sound or noise is heard while receiving
radio broadcast.
≥ Confirm the FM antenna is properly connected. (> 8)
≥ Adjust the position of the antenna.
≥ Try to keep a certain amount of distance between the
antenna and AC power supply cord.
≥ Try to use outdoor antenna if there are buildings or
mountains nearby.
≥ Switch the television or other audio player off or
separate it from the unit.
≥ Keep this unit away from mobile phones if the
interference is apparent.
Automatic standby
Display brightness
Changing the main unit and
remote control code
To return all settings to the factory preset
When the following situations occur, reset the
memory:
≥ There is no response when buttons are pressed.
≥ You want to clear and reset the memory contents.
1 Disconnect the AC power supply cord. (Wait
for at least 3 minutes before proceeding to
step 2.)
2 While pressing and holding down [ Í/I] on the
main unit, reconnect the AC power supply
cord.
≥ “--------” appears on the display.
3 Release [ Í/I].
All the settings are returned to the factory preset. You will
need to reset the memory items.
Common problems
Disc operations
Radio
SC-HC37~RQT9633.book 12 ページ ２０１２年２月２８日 火曜日 午後３時４３分