Pacific Digital Digital Pacific USB Digital Photo Frame MemoryFrame - Manual (Page 59)

MemoryFrame User’s Manual
Copyright© 2002 Pacific Digital Corporation
Page 56
The MemoryFrame will display the following sequence of messages
to show the progress of the firmware update:
“FLASH BEING ERASED”
“FLASH BEING LOADED”
“READING FLASH”
“VERIFYING FLASH”
If an error occurs in the above process (either
erase, loading, or verification), the MemoryFrame will display the
following message:
“REDO FLASH- DON’T POWER OFF ( error code number)”
Caution! Important! Do not unplug or cut power to the
MemoryFrame or PC. The above error message indicates that there
was an error (either erase, loading, or verification) during the
firmware update. The firmware update MUST BE RE-DONE and
the PICTURE FRAME MUST NOT BE POWERED OFF BEFORE
THAT during the upgrade process! A loss of power could erase both
old and new operating systems, leaving the MemoryFrame
inoperable.
If no errors occur, then once the new firmware update file has been
loaded into the MemoryFrame’s storage memory, the
MemoryFrame will indicate it is done by displaying the following
message indicating when you can reset the MemoryFrame:
“PLEASE POWER THE MEMORYFRAME OFF/ON”
Only then can you turn the MemoryFrame OFF, then turn it back
ON. When the MemoryFrame goes into normal operation, the
upgrade has been completed.
Enjoy the new firmware!