Powermatic 3520B - Manual (Page 7)

7
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Lathe is
assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Some parts can be found in separate
boxes packed around the Lathe. Missing parts, if
any, should be reported to your distributor. Read
the instruction manual thoroughly for assembly,
maintenance and safety instructions.
Contents of the Shipping Container
1 Lathe Bed, with Headstock, Tailstock, &
Tool Support Base – (A)
2 Leg Assemblies – (B)
1 Guard – (C)
1 Tool Support, 14” – (D)
1 Face Plate, 3” – (E)
1 Live Center – (F)
1 Spur Center, 1” – (G)
1 Index Pin – (H)
1 Live Center Pin – (J)
1 Knockout Rod – (K)
1 Face Plate Wrench – (L)
1 Tool Caddy – (M)
4 Levelers – (N)
12 Socket Hd. Cap Screws, 3/8” x 1-1/4” – (O)
12 Lock Washers, 3/8” – (P)
10 Flat Washers, 3/8” – (R)
2 Comparator Centers – (S)
1 Comparator Rear Bracket with
Lock Handle – (T)
1 Owner's Manual
1 Warranty Card
Read and understand the entire contents of this manual before attempting set-up
or operation! Failure to comply may cause serious injury.