Setting and fastening the door (continued), Head ~ 8” j a m b – Pella 81DU0100 User Manual

Page 9

INTEGRATING THE DOOR TO THE

WATER RESISTIVE BARRIER:

&YUFSJPS

Note: The ﬂashing tape must be applied
approximately 1/2" onto the frame cladding at the
jambs and head. Pre-folding the tape at 1/2" before
removing the paper backing will make it easier to
apply the tape correctly. If the siding is less than 1/2"
thick, adjust the dimension of the fold so the exterior
sealant line will cover the exterior edge of the tape.

A. Apply side ﬂashing tape. Cut two pieces of ﬂashing

WDSHORQJHUWKDQWKHIUDPHKHLJKWRIWKHGRRU
$SSO\RQHSLHFHRQWRWKHIUDPHFODGGLQJRYHU
the nailing fin and onto the water resistive barrier on
HDFKVLGH7KHWDSHVKRXOGH[WHQGDERYHWKHWRS
RIWKHGRRUDQGEHORZWKHERWWRPRIWKHGRRU
Press the tape down firmly while folding down the
H[FHVVWDSHDWWKHWRSDQGERWWRPRIWKHGRRU

P. Doors with a lock strike in the side (jamb) and without a sidelight on the lock side:

'ULOODQGLDPHWHU[GHHSSLORWKROHLQWRWKHURXJKRSHQLQJWKURXJKWKHSUHGULOOHG
holes located in the frame as follows:

3Door Frame Corner:

Drill pilot holes through the pre-drilled hole located in the upper frame corner on the lock
MDPEVLGHDSSUR[LPDWHO\IURPWKHWRSRIWKHGRRUIUDPHKHDG

3Doors with Multi-point Lock:

Drill through the one pre-drilled hole located in each lock strike. (Pull back frame
weatherstrip to locate open hole in strike).

3Center Latch and Deadbolt Lock:

'ULOOWKURXJKWKHPRXQWLQJKROHORFDWLRQV,QVHUWD[VFUHZLQWRWKHSLORWKROHV
making sure it passes through the shim and into the rough opening.
Note: This step does not apply to center latching double doors.

SETTING AND FASTENING THE DOOR (continued):

Head

~ 8”

3P1

3P3

3P2

Pull back weatherstrip to expose strike hole.

Flashing

Tape