Setting and fastening the door (continued) – Pella 81DU0100 User Manual

Page 7

F. Check the interior reveal. 0DNHVXUH

the measurement from the interior face
of the door to the interior face of the
wall is equal at several points around
the door.
Note: If dimensions are not equal,
check to make sure the ﬁns are folded
out to 90° at all points.

* Fasten the door WRRSHQLQJE\GULYLQJJDOYDQL]HGURRŵQJQDLOLQWRHDFKSUH

punched hole in the nailing ﬁn.
Note: Make sure the ﬁn corner is lying as ﬂat as possible

H. Carefully open the door(s) and

remove all shipping spacers.
Note: Be sure to remove the
spacers from the bottom edge
of the door panel.

Double Doors with Multipoint latch in center:

Use the construction handle to operate

the active door handle. Operate the ﬂushbolts per the instructions on the label on
the strike located on the astragal.

I. Designer Series® Out-Swing: Install sill screws. Place a dab of sealant in each

RIWKHSUHGULOOHGKROHVLQWKHERWWRPRIWKHXQLWVLOO7KHQLQVHUWD[
FRUURVLRQUHVLVWDQWVFUHZSURYLGHGLQWRHDFKKROH)RUPDVRQU\ŶRRUVXVD
PDVRQU\VFUHZLQSODFHRIWKHSURYLGHGVFUHZSLORWGULOOSHUVFUHZPDQXIDFWXUHUőV
recommendations.

All other:

Sill screws are not needed.

For combinations (Multi-wide): 3UHGULOOIUDPHDWPXOOLRQHQGV IURPHDFK

PXOOLRQMRLQWDQGLQVHUW[FRUURVLRQUHVLVWDQWVFUHZV)RUPDVRQU\DSSOLFDWLRQV
XVHPDVRQU\VFUHZV

J. For Low Proﬁle Sills: 7KURXJKHDFKLQVWDOODWLRQVFUHZKROHGULOODSLORWDQGLQVWDOO

D[FRUURVLRQUHVLVWDQWVFUHZSURYLGHGLQWRWKHSLORWKROHLQWRWKHŶRRU)RU
doors including a standard lock install tubs per instruction included with the sill strike
package.
Note: For concrete ﬂoors use masonry screws a minimum size of 3/16" diameter x 3"
and pilot per manufacturer’s recommendations for the screw.

SETTING AND FASTENING THE DOOR (continued):

Interior

2 0 3 0 40

5 0 6 0 70

INCHES

Clip or Frame Screw Installation,
go to Step 5I