Lantronix XPress DR+ - Manual (Page 112)

Appendix E: Compliance Information
XPress DR+ User Guide 112
XPress DR+W Regulatory Information
USA Federal Communications Commission (FCC) Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause
undesired operation.
Caution: Changes or modifications to this product not expressly approved by Lantronix
could void the user's authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
‹ Reorient or relocate the receiving antenna.
‹ Increase the separation between the equipment and receiver.
‹ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
‹ Consult the dealer or an experienced radio/TV technician for help.
Caution: Exposure to Radio Frequency Radiation
The equipment contains transmitter with FCC ID: R68XSDRWLSG
The antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter. Installers and end-
users must be provided with antenna installation instructions and transmitter
operating conditions for satisfying RF exposure compliance.
Canada – Industry Canada Notice
This device complies with Industry Canada RSS-210 regulations
(IC: 3867A-XSDRWLSG). Operation is subject to the following two conditions:
‹ This device may not cause interference, and
‹ This device must accept any interference, including interference that may cause
undesired operation of the device.
To prevent radio interference to the licensed service, this device must be operated
indoors only and should be kept away from windows to provide maximum shielding.