Lincoln Electric OUTBACK SVM204-A User Manual
Outback, Svm204-a, Service manual
Table of contents
Document Outline
- Master Table of Contents
- Safety
- Section A - Installation
- Section B - Operation
- Section C - Accessories
- Section D - Maintenance
- Section E - Theory of Operation
- Section F - Troubleshooting and Repair
- Symptoms
- Major physical or electrical damage.
- The engine will not crank while using the electric start function.
- Engine will not start. The starter motor will crank the engine normally.
- The engine will not shut down.
- The engine runs erratically or stops running.
- Engine will not idle down. Weld and auxiliary outputs are normal.
- Engine idles own but will not stay at low idle.
- The engine will not go to high idle when a welding or auxiliary load is applied. Engine idles up normally and outputs are normal when the engine switch is placed in the “high” position.
- No weld or auxiliary output –Engine runs normally.
- There is no weld output, or weld voltage drops dramatically when trying to strike an arc. The 115/230 VAC auxiliary output isnormal; engine operate snormally.
- No 115/230 VAC auxiliary output – Weld output is normal and engine operates normally.
- Low weld and auxiliary output, the engine operates normally.
- The welding arc is “cold” or weld performance is poor. Engine operates normally and auxiliary output is normal.
- Section G - Electrical Diagrams