Linksys RV082 - Manual (Page 62)

53 Chapter 6: Set Up and Configure the Router
VPN Tab - VPN Pass Through
10/100 8-Port VPN Router
VPN Tab - VPN Pass Through
IPSec Pass Through See Figure 6-49.
Internet Protocol Security (IPSec) is a suite of protocols used to implement secure exchange of packets at the IP
layer. IPSec Pass Through is enabled by default to allow IPSec tunnels to pass through the Router.
PPTP Pass Through
Point to Point Tunneling Protocol (PPTP) Pass Through is the method used to enable VPN sessions. PPTP Pass
Through is enabled by default.
L2TP Pass Through
Layer 2 Tunneling Protocol (L2TP) Pass Through is the method used to enable VPN sessions. PPTP Pass Through
is enabled by default.
Click the Save Settings button when you finish the VPN Pass Through settings, or click the Cancel Changes
button to undo the changes.
Log Tab - System Log
System Log
There are three parts in System Log. Syslog, E-mail and Log Setting. See Figure 50.
Syslog
Enable Syslog: If you check the box, Syslog will be enabled.
Syslog Server: In addition to the standard event log, the Router can send a detailed log to an external Syslog
server. Syslog is an industry-standard protocol used to capture information about network activity. The Router’s
Syslog captures all log activity and includes every connection source and destination IP address, IP service, and
number of bytes transferred. Enter the Syslog server name or IP address in the Syslog Server field. Restart the
Router for the change to take effect.
E-mail
Enable E-Mail Alert: If you check the box, E-Mail Alert will be enabled.
Figure 6-49: VPN Pass Through
Figure 6-50: System Log