Land Pride Rear Blades RBT4096 - Manual (Page 17)

15
Section 3: Set-Up of Accessories
RBT4084, RBT4096 & RBT40108 Rear Blades 301-206M 6/12/13
Table of Contents
Hydraulic Cushion Valve
Kit Bundle for Cushion Valve & Hoses
301-208A . . . . . . . . . . . . . . For RBT4084 & RBT4096
301-187A . . . . . . . . . . . . . . . . . . . . . . . .For RBT40108
Refer to Figure 3-2:
1. Attach cushion valves (#1 & #2) to the mounting plate
with 3/8"-16 x 4" GR5 hex head cap screw (#3),
spring lock washer (#4), and hex hut (#5). Tighten
hex nuts to the correct torque.
2. Screw all eight fittings (#6) into the cushion valves
(#1 & #2) until tight.
3. Attach existing hydraulic hose (#7) to the right rear
fitting of cushion valve (#2) as shown.
4. Attach existing hydraulic hose (#8) to the right front
fitting of cushion valve (#1) as shown.
5. Attach existing hydraulic hose (#9) to the left rear
fitting of cushion valve (#1) as shown.
6. Attach existing hydraulic hose (#10) to the left front
fitting of cushion valve (#2) as shown.
7. Attach four new 48" long hydraulic hoses (#11) to the
remaining fittings (#6).
8. Thread all hoses through hose retainer (#12).
!
CAUTION
Do not operate Rear Blade with either the angling or offset
hydraulic cylinder fully extended. Fully extending either
cylinder will keep the cushioning valves from operating
correctly.
Hydraulic Cushion Valve Assembly
Figure 3-2
25538
FRAME OFFSET
HYDRAULIC
CYLINDER
BLADE ANGLING
HYDRAULIC
CYLINDER