Replacing the mouse – Lenovo 5046 User Manual
Page 47
to connect your keyboard, see “Locating connectors, controls, and indicators on the front of your
computer” on page 6 or “Locating connectors and parts on the rear of your computer” on page 7.
Figure 39. Keyboard connectors
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 40.
Replacing the mouse
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the mouse.
To replace the mouse, do the following:
1. Remove all media from the drives. Then, turn off all attached devices and the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the old mouse cable from the computer.
4. Connect a new mouse to the appropriate connector on the computer. Your mouse might be connected
to a PS/2 mouse connector
1
or a USB connector
2
. Depending on where you want to connect your
mouse, see “Locating connectors, controls, and indicators on the front of your computer” on page 6 or
“Locating connectors and parts on the rear of your computer” on page 7.
Figure 40. Mouse connectors
Chapter 2
.
Installing or replacing hardware
39