Replacing the optical drive – Lenovo 5046 User Manual
Page 39
Replacing the optical drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the optical drive.
To replace the optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 14.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 14.
4. Pivot the drive bay assembly upward. See “Accessing the system board components and drives”
5. Disconnect the signal cable and the power cable from the optical drive.
6. Hold the optical drive and remove the two screws that secure the optical drive.
Figure 27. Removing the optical drive screws
7. Press the drive bay assembly clip
1
inward and pivot the drive bay assembly downward as shown.
Chapter 2
.
Installing or replacing hardware
31