beautypg.com

Lenovo 5046 User Manual

Page 41

background image

Figure 30. Installing a new optical drive

10. Hold the new optical drive and pivot the drive bay assembly upward. Align the screw holes in the new

optical drive with the corresponding holes in the drive bay. Then, install the two screws to secure
the new optical drive in place.

Figure 31. Installing the optical drive

11. Connect one end of the signal cable to the rear of the new optical drive and the other end to an available

SATA connector on the system board. See “Locating parts on the system board” on page 9. Then,
locate an available five-wire power connector and connect it to the rear of the new optical drive.

Chapter 2

.

Installing or replacing hardware

33

This manual is related to the following products: