Liebherr HC1050 - Manual (Page 34)

A delight in freshness
HC 1001 / HC 1050
29
F
REEZER
C
OMPARTMENT
To turn OFF
If you do not need any ice cubes, the IceMaker can
be turned off independently of the freezer
compartment.
●
Press the “ON/OFF” button for approximately
1 second so the control lamp goes out.
Note
If the IceMaker is turned off, the empty drawer can
also be used to freeze and store food.
To make ice cubes
After you start the icemaker for the first time it may
take up to 24 hours before the first ice cubes are
ready.
Note
The first three batches of ice must not be consumed
or used. This will help ensure that the water supply
lines are free of contaminants.
The production capacity depends on the tempera-
ture inside the freezer compartment. The lower the
temperature, the more ice can be produced over a
period of time.
The ice cubes fall out of the icemaker into the
drawer.When the ice reaches a certain level in the
drawer, the appliance stops producing ice automati-
cally.
If you need a large quantity of ice you can change
out the drawer to the right with the complete “Ice-
Maker” drawer. When you close the drawer the
icemaker will immediately start production.
To Start the IceMaker
- Figure 39
The IceMaker will only work if the combined refrig-
erator-freezer is connected to the electrical outlet. It
will only make ice cubes if the freezer compartment
is operating and if the minimum freezer temperature
is 14°F (-10°C).
The IceMaker is in the top left drawer in the freezer
compartment of the combined refrigerator-freezer.
You can identify this drawer by its labeling “IceMaker.”
To turn ON
●
Pull out the drawer.
●
Press the “ON/OFF” button so the control lamp
comes on (Figure 39).
●
Close the drawer.
Note
The IceMaker can only make ice cubes if the
drawer is completely closed.
Figure 39