Lexmark MARKNET N8050 User Manual
Page 22
Configuring the print server in Ad-Hoc mode
18
3
Change the current wireless network parameters to the following values:
4
Check the IP address of the printer.
The printer will be assigned an IP address through the AutoIP method. This address should
be in the range of 169.254. Access the printer IP address by one of the following methods:
•
Print a network setup page. For more information on printing a network setup page, see
, or see the printer documentation.
•
Use the IP Setup Utility located on the
MarkNet N8050 Utilities
CD to display the print
server IP address.
5
Make sure the PC has assigned itself an IP address that is different than the printer, but is still
within the same IP range. For example:
If the computer IP address is not within the same range as the print server, the IP address will
need to changed so that it is within the appropriate range.
For information on locating and changing the computer IP address, see the computer or
operating system documentation.
6
Open a Web browser, and enter the print server IP address as the URL to access the
embedded Web page of the print server.
Note:
If 802.1x–RADIUS is the intended Wireless Security Mode for the network, and a
signed certificate and/or CA certificate is required for the authentication method,
see
to establish the necessary certificates before
continuing with the configuration process.
7
Click
Configuration
on the left side of the Web page.
8
Under Other Settings, click
Network/Ports
.
Wireless network
parameter
Set to
SSID (Network Name
or Service Set ID)
print server
Basic Service Set
Type (BSST)
Ad-Hoc
Data Encryption Mode
None
WEP Key
None
Device
IP address
Computer
169.254.10.40
Print server
169.254.10.41