beautypg.com

Start-up – Lochinvar Condensing Boiler 1.5 User Manual

Page 41

background image

41

Installation & Operation Manual

9

Start-up

(continued)

Check for gas leaks

Before starting the boiler, and during
initial operation, smell near the floor and
around the boiler for gas odorant or any
unusual odor. Remove the top access
panel and smell the interior of the boiler
enclosure. Do not proceed with startup
if there is any indication of a gas leak.
Use an approved leak detection solution.
Repair any leaks at once.

DO NOT adjust or attempt to measure
gas valve outlet pressure. The gas valve is
factory set for the correct outlet pressure.
This setting is suitable for natural gas and
propane, requiring no field adjustment.
Attempting to alter or measure the gas
valve outlet pressure could result in
damage to the valve, causing potential
severe personal injury, death, or
substantial property damage.

Propane boilers only – Your propane
supplier mixes an odorant with the propane
to make its presence detectable. In some
instances, the odorant can fade, and the
gas may no longer have an odor. Before
startup (and periodically thereafter), have
the propane supplier verify the correct
odorant level in the gas.

Check thermostat circuit(s)

1. Disconnect the two external wires connected to the

enable terminals on the connection board.

2. Connect a voltmeter across these two incoming wires.

Close each thermostat, zone valve, and relay in the
external circuit one at a time and check the voltmeter
reading across the incoming wires.

3. There should NEVER be a voltage reading.

4. If a voltage does occur under any condition, check and

correct the external wiring. (This is a common problem
when using 3-wire zone valves.)

5. Once the external boiler enable wiring is checked and

corrected if necessary, reconnect the external thermostat
circuit wires to the connection board. Allow the boiler to
cycle.

Inspect condensate system

Inspect/check condensate lines and fittings

1. Inspect the condensate drain line, condensate PVC

fittings and condensate trap.

FROM CONDENSATE
VENT ON BOILER

FROM CONDENSATE
DRAIN ON BOILER

TO FLOOR DRAIN
OR NEUTRALIZER KIT
1” PVC / CPVC CONNECTION

Figure 9-1 Condensate Trap

ƽ WARNING

ƽ WARNING

ƽ WARNING

This manual is related to the following products: