Lanier 1027 - Manual (Page 176)

Troubleshooting
164
3
x x x x Clearing Misfeeds
R CAUTION:
Important
❒ When clearing misfeeds, do not turn off the operation switch. If you do, your
copy settings are cleared.
❒ To prevent misfeeds, do not leave any torn scraps of paper within the ma-
chine.
❒ If paper misfeeds occur repeatedly, contact your service representative.
Note
❒ More than one misfed area may be indicated. In this case, check every appli-
cable area. See the following charts: A, B, C, D, P, R, Y, Z
❒ You can find a sticker explaining how to remove misfed paper inside the front
cover or inside the finisher.
• The fusing section of this equipment might be very hot. You should be very
careful that you don't touch this section when removing the misfed paper.