beautypg.com

Troubleshooting & repair, Stator/rotor removal and replacement (continued) – Lincoln Electric POWER-ARC 4000 SVM103-A User Manual

Page 71

background image

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

POWER-ARC 4000

TROUBLESHOOTING & REPAIR

F-30

STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)

FIGURE F.9 - OUTPUT LEAD LOCATION

OUTPUT
TERMINALS

W1

W2

TIE WRAP

STATOR REMOVAL PROCEDURE

1. Remove engine spark plug wire to prevent

accidental kickback or starting.

2. With the 5/16” nut driver, remove the 4

sheet metal screws that hold the top cover
to the control box. Remove the top cover.

3. Remove the 4 1/2” nuts and washers that

anchor the control box to the stator frame.
Two of the nuts also anchor the reactor.
The reactor must be moved over to access
the front left hand nut anchoring the control
box. Be careful not to drop the washers into
the machine.

4. Lift up the control box and unscrew the 4

rubber mounts. Set the control box onto the
stator frame for the moment.

5. Pull apart the molex coupling that connects

the stator to the wiring harness.

6. With the slot head screw driver, remove the

6 sheet metal screws that hold the control
panel to the control box - 3 on each side.
You may need to use the 5/16” end wrench
on the engine side because of limited clear-
ance. Pull the panel away from the control
box.

7. With the 9/16” open end wrench, remove

lead W2 (Black) from the output terminal.
See Figure F.9 for location. With the diago-
nal cutters, cut the cable tie that holds the
two output leads together. Pull lead W2
back out of the way; screw the bolt back

into the output terminal hole loosely for
reassembly. Set the control panel back on
the control box and hold it in place with 1
sheet metal screw in each side.

8. Remove the brush holder assembly. Open

the brush holder assembly cover. Squeeze
the 2 tabs and depress the cover at the top
with a screw driver or your fingernail. The
cover will drop open on its bottom hinge.
With the 1/4” nut driver, remove the 2
screws that hold the brush holder assembly
in place. With the needle nose pliers, gently
remove the black and the red wires. Set the
brush holder aside. Pull the wires up into
the control box.

9. Pull apart the molex coupling for the engine

flywheel alternator. This is the single wire on
the left side of the machine, running from
the engine to the stator.

10. Disconnect lead W1 (Black) that connects

to the reactor lead. Replace the nut, split-
ring lock washer, and flat washer finger
tight on the bolt for reassembly.

11. Slide the control panel and box assembly

out of the machine cradle. Carefully pull
the wire leads down through the box as
you remove it. Note that the reactor is
loose inside the box and may slide around.