Lincoln Electric POWER-ARC 4000 SVM103-A - Manual (Page 30)

Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
OPTIONS/ACCESSORIES
LINCOLN ELECTRIC ACCESSORIES
The following options/accessories are available for
your POWER-ARC 4000 from your local Lincoln
Distributor.
Power Plug Kit (K802T) – Provides three plugs, two
for the 120 volt duplex receptacle and one for the 240
volt receptacle.
Accessory Set (K875) – Includes the following:
• Twenty feet (6.1 meters) of #6 AWG electrode cable
• Fifteen feet (4.6 meters) of #6 work cable
• Headshield with No. 10 filter, work clamp
• Insulated electrode holder and sample electrodes
The cables are rated at 150 amps, 40% duty cycle.
Spark Arrester (K883-1) – A field-installed kit for the
8 HP Briggs & Stratton Cool-Bore
® engine. The spark
arrestor attaches to the muffler to reduce the change
of sparks being emitted from the muffler.
Rotor Removal Kit (S20925) – A service kit with thru
and impact bolts for removing the generator rotor from
the tapered engine crankshaft.
BRIGGS AND STRATTON ACCESSORIES
The following options/accessories are available for
your POWER-ARC 4000 from your local Briggs &
Stratton Distributor.
Foam Pre-cleaner (REF 271794) – Provides a foam
cleaner for replacement around the paper cartridge air
cleaner. Increases protection in extremely dusty or
dirty environments.
Oil Gard ® Low Oil Shutdown Kit (REF 398182) –
Installs in the crankcase access port standard on all
POWER-ARC models. Senses low oil conditions and
automatically stops the engine. The engine cannot be
restarted until sufficient oil is added.
Super Lo-Tone ® Muffler - Square (REF 494221) –
Replaces the round Lo-Tone muffler that comes
installed on the engine. Limits exhaust noise but
reduces maximum generator output by 200-300 watts.
Muffler Guard (REF 494868) – Installs onto the muf-
fler with a supplied bracket. Protects against acci-
dental contact with a hot muffler. Must not be used in
tandem with both a deflector and a spark arrester.
SEMIAUTOMATIC MIG WELDING
WITH A LINCOLN WELD-PAK 100
OR WELD-PAK 125
In addition to using the accessories/options listed
above, the POWER-ARC 4000 generator can supply
power to a Lincoln ELectric Weld-Pak 100 or Weld-
Pak 125 wire feed welder. The Weld-Pak comes with
all the supplies needed for Flux-Cored Arc Welding
(FCAW).
A K610-1 MIG (Metal Inert Gas) Conversion Kit is also
available for the Weld-Pak. The kit provides every-
thing needed for Gas Metal Arc Welding (GMAW) or
MIG processes. Contact your local authorized Lincoln
representative for details about the Weld-Pak and MIG
Conversion Kit.
POWER-ARC 4000
C-1
ACCESSORIES