Lincoln Electric INVERTEC IM958 - Manual (Page 13)

A-4 INSTALLATION
V310-T AC/DC TIG
A-4
INPUT PLUG INSTALLATION
POWER CORD CONNECTION
A 10 ft. power cord is provided and wired into the
machine. Follow the power cord connection instruc-
tions.
Single Phase Input
Connect green lead to ground per National Electrical
Code.
Connect black and red leads to power.
Wrap white lead with tape to provide 600V insulation.
Three Phase Input
Connect green lead to ground per National Electric
Code.
Connect black, red and white leads to power.
• Failure to wire as instructed may cause personal
injury or damage to equipment. To be installed
or checked by an electrician or qualified person
only.
---------------------------------------------------------------------------
In all cases, the green or green/yellow grounding wire
must be connected to the grounding pin of the plug, usu-
ally identified by a green screw.
Attachment plugs must comply with the Standard for
Attachment Plugs and Receptacles, UL498.
The product is considered acceptable for use only when
an attachment plug as specified is properly attached to
the supply cord.
For use on engine drives, keep in mind the above input
draw restrictions and the following precaution.
ENGINE DRIVEN GENERATOR
The Invertec V310-T AC/DC TIG can be operated on
engine driven generators as long as the 230 volt auxil-
iary meets the following conditions:
• The AC waveform peak voltage is below 400 volts.
• The AC waveform frequency is between 45 and
65Hz.
The following Lincoln engine drives meet these condi-
tions when run in the high idle mode:
• Ranger 250, 305
• Vantage 300, 400, 500
Some engine drives do not meet these conditions
(e.g. Miller Bobcats, etc). Operation of the Invertec
V310-T AC/DC is not recommended on engine drives
not conforming to these conditions. Such drives may
deliver unacceptably high voltage levels to the
Invertec V310-T AC/DC power source.
WARNING