Linksys WAG325N - Manual (Page 7)

Chapter3
Installation
Wreless-N ADSL2+ Gateway
Chapter 3: Installaton
Linksys strongly recommends that you run the Setup CD-
ROM. If you have problems running the Setup CD-ROM,
use this chapter.
Connection
Make sure that all the devices that you are working
with are powered down, including your computer(s)
and the Gateway. If you have a modem connected to
your network, disconnect it. Your Gateway replaces
your modem.
Connect one end of the provided phone cable to the
wall jack with ADSL service.
Connect the other end of the phone cable to the DSL
port on the back of the Gateway.
Connect the DSL
NOTE: To avoid interference, you may need
to place a microfilter or splitter between the
phone cable and wall jack. Contact your ISP to
determine if one is required. (UK residents need
to connect the microfilter to the wall phone jack
with ADSL service and then connect one end of
the provided phone cable to the RJ-11 port on it.)
If you use ISDN, then you do not need a
microfilter.
Connect one end of the provided Ethernet cable to
your computer’s Ethernet adapter. Connect the other
end of the Ethernet cable to one of the Ethernet ports
on the back of the Gateway.
Connect the Computer
1.
2.
3.
4.
Repeat steps 1-4 for every computer or device that
you want to connect to the Gateway via Ethernet.
If you connect more than four computers to the
Gateway, you also need to connect a switch to the
Gateway.
NOTE: If your computer’s Ethernet adapter
is not set up, refer to the Ethernet adapter’s
documentation for more information.
Connect the power adapter to the Gateway’s power
port and the electrical outlet.
Connect the Power
Power on the Gateway.
Power on the computer that you want to use to
configure the Gateway.
NOTE: If you have more than one phone and you
experience static on the line after installing the
Gateway, then you need to install an additional
microfilter for each phone or fax that you use.
Connecton s complete.
Contnue to the “Setup” secton.
Setup
For setup, configure the Gateway to access the Internet
through your ADSL Internet Service Provider (ISP). Use the
setup information provided by your ISP.
Continue to “Chapter 4: Advanced Configuration”, and
complete the following sections:
Setup > Basic Setup
Wireless > Basic Wireless Settings
Wireless > Wireless Security
After completing the setup, to test it, enter
www.lnksys.com/regstraton in the web browser’s
Address field, and press Enter.
Installaton s complete.
5.
6.
7.
8.
•
•
•