Linksys WAG325N - Manual (Page 27)

Chapter3
Advanced Configuration
2 Wreless-N ADSL2+ Gateway
Prorty Select the appropriate priority: Hgh, Medum,
Normal, or Low.
Click the Add button to save your changes. Your new entry
will appear in the Summary list.
Summary
This lists the QoS entries you have created for your
applications and devices.
Prorty This displays the bandwidth priority of Hgh,
Medum, Normal, or Low.
Name This displays the application, device, or port
name.
Informaton This displays the port range or MAC address
entered for your entry. If a pre-configured application or
game was selected, there will be no valid entry shown in
this section.
Remove Click this button to remove an entry.
Edt Click this button to make changes..
Click Save Settngs to apply your changes, or click Cancel
Changes to cancel your changes.
Administration > Management
The Administration > Management screen allows the
network’s administrator to manage specific Gateway
functions for access and security.
Administration > Management
Gateway Access
Local Gateway Access
To ensure the Gateway’s security, you will be asked for your
User Name and password when you access the Gateway’s
web-based utility. The default User Name and password
are admn.
Gateway Userlst Select the number of the user. The
default is user 1.
Gateway User Name Enter the default Gateway User
Name, admn.
Gateway Password Linksys recommends that you
change the default Gateway Password, admn, to one of
your choice.
Re-enter to Confrm Enter the Gateway Password again
to confirm.
For non-admin users, select a different user number, and
then configure the Gateway User Name and Password
settings.
Remote Gateway Access
Remote Management To permit remote access of the
Gateway, from outside the local network, select Enable.
Otherwise, keep the default, Dsable.
Management Port Enter the port number that will be
open to outside access.
NOTE: When you are in a remote location
and wish to manage the Gateway, enter
http://:port. Enter
the Gateway’s specific Internet IP address in
place of , and enter
the Management Port number in place of the
word port.
SNMP
SNMP is a popular network monitoring and management
protocol.
Devce Name Enter the name of the Gateway.
SNMP To use SNMP, select Enable. Otherwise, select
Dsable.
Get Communty Enter the password that allows read-only
access to the Gateway’s SNMP information.
Set Communty Enter the password that allows
read/write access to the Gateway’s SNMP information.
Trap Management: Trap to Enter the IP address of
the remote host computer that will receive the trap
messages.