beautypg.com

Gas connections, Connecting gas supply piping – Lochinvar Shield SNR200-100 User Manual

Page 39

background image

39

7

Gas connections

Connecting gas supply piping

1. Install ground joint union for servicing, when
required.

2. On Models SNR150-100 -- SNA285-125 install a manual

shutoff valve in the gas supply piping outside water heater

jacket when required by local codes or utility requirements.


3. In Canada – When using manual main shutoff valves, it

must be identified by the installer.

GAS SUPPLY

DRIP LEG

MANUAL GAS
SHUT OFF VALVE
(FIELD SUPPLIED)

UNION

Figure 7-1 Gas Supply Piping - Models SNR150-100
-- SNA285-125

4. Support piping with hangers, not by the water heater or its

accessories.

Do not check for gas leaks with an open
flame – use the bubble test. Failure to use the
bubble test or check for gas leaks can cause
severe personal injury, death, or substantial
property damage.

GAS SUPPLY

DRIP LEG

MANUAL GAS

SHUTOFF VALVE

(FACTORY SUPPLIED ON

MODELS SNA400-125 --

SNA500-125)

UNION

Figure 7-2 Gas Supply Piping - Models SNA400-125
-- SNA500-125

5. Purge all air from the gas supply piping.

6. Before placing the water heater in operation, check the

water heater and its gas connection for leaks.


a. The appliance must be disconnected from the gas

supply piping system during any pressure testing of

that system at a test pressure in excess of 1/2 PSIG

(3.5 kPa).

b. The appliance must be isolated from the gas supply

piping system by closing a manual shutoff valve

during any pressure testing of the gas supply piping

system at test pressures equal to or less than 1/2 PSIG

(3.5

kPa).

c. The appliance and its gas connection must be leak

tested before placing it in operation.

The gas valve and blower will not support
the weight of the piping. Do not attempt to
support the weight of the piping with the
water heater or its accessories. Failure to
comply could result in severe personal injury,
death, or substantial property damage.

ƽ WARNING

ƽ WARNING

7. Use pipe sealing compound compatible with propane gases.

Apply sparingly only to male threads of the pipe joints so
that pipe dope does not block gas flow.

Installation & Service Manual

TM