Life Fitness Peak Pilates Reformer - Manual (Page 49)

46 Maintaining the Peak PilateSystem
• Springs, Safety Chain and Clips – We strongly recommend that you inspect all springs, safety
chain and clips weekly. Even with extensive pre-testing and rigorous quality inspection, the
possibility of failure exists. In addition, severe nicks or abrasions may develop as a result of
misuse and could lead to premature spring breakage. Not replacing springs in a timely manner will
also lead to failure. While the breakage or deformation of a spring and the resulting potential for
serious injury is a remote possibility, periodic inspection of your springs is critical.
The springs are zinc-plated to prevent rust or corrosion from perspiration, condensation and
humidity. Variation in the brightness of the finish is the result of different plating batches and does
not affect the superb performance of our springs.
• Tracking System – The sealed bearings in the Carriage Wheels are permanently lubricated and
require no further lubrication. You should inspect the Wheel Axles every 2 months. Remove any
debris that might be entwined between the wheel and steel carriage frame, and tighten the axles if
any wheel “play” is evident. Wheel “play” is unlikely but worth a periodic check.
Clean
• Framework – The wooden components on this equipment are finished with a non-toxic, water-
based lacquer. Other than an occasional wipe down using a mild soapy solution or furniture polish,
no additional cleaning is necessary. The metal framework should be cleaned with a mild soapy
solution.
• Upholstery – We recommend wiping down your vinyl upholstery with a mild cleaning solution
after each use. Mix 1 part Simple Green and 12 parts water in a spray bottle.
• Tracking System – The tracks upon which your carriage rides are anodized to inhibit the build-up
of unsightly aluminum oxide residue. Clean them on an as-needed basis using a warm, mild soapy
water solution and dry thoroughly with a soft cloth.
Replace
• Springs – We recommend that you replace all of the springs every year. Any spring that exhibits
early signs of fatigue (for example, separation in coils, even if slight) should be replaced
immediately.
• Ropes – You may experience some minor “fraying” or “pilling” on the cotton rope. “Fraying” or
“pilling” is completely normal and to be expected. Any ropes that tear or otherwise fail should be
replaced immediately. The ropes can be used until the “fraying” affects their function.
• Foot Loops, Handles and Safety Clips – These parts wear over time. Replace them as needed.
Warning: Ensure that any person(s) making adjustments or performing maintenance or repair
of any kind is qualified to do so.