Linksys RV0041 - Manual (Page 56)

48 Chapter 5: Setting Up and Configuring the Router
VPN Tab - Client to Gateway
10/100/1000 4-Port VPN Router
the Internet. RV0041 will get the IP address of remote VPN device by DNS Resolved, and IP address of remote
VPN device will be displayed on VPN Status of Summary page.
IP + Domain Name (FQDN) Authentication: f you know the static IP address of remote client, select IP address
from drop-down menu. If you don't know the static IP address of remote client, but the domain name of
remote client is known, you can select IP by DNS Resolved, and enter the real domain name on the Internet.
RV082 will get the IP address of remote client by DNS Resolved, and IP address of remote client will be
displayed on VPN Status of Summary page. Then, enter the Domain Name as an ID, it can be not a real domain
name on Internet. The IP and Domain Name ID must be same with the Local setting of the remote client, and
the same IP and Domain Name ID can be only for one tunnel connection.
IP + E-mail Addr. (USER FQDN) Authentication: If you know the static IP address of remote client, select IP
address from drop-down menu. If you don't know the static IP address of remote client, but the domain name
of remote client is known, you can select IP by DNS Resolved, and enter the real domain name on the Internet.
RV082 will get the IP address of remote client by DNS Resolved, and IP address of remote client will be
displayed on VPN Status of Summary page. Then, enter E-mail Address as an ID.
Dynamic IP + Domain Name (FQDN) Authentication: This setting uses a dynamic IP address, which is
constantly changing. In addition, the tunnel is confirmed through use of a domain name. Only one domain
name can be used for one tunnel and may not be applied to another tunnel.These settings must match the
Remote Group Setup on the other end of the tunnel.
Dynamic IP + E-mail Addr.(USER FQDN) Authentication: This setting uses a dynamic IP address, which is
constantly changing. In addition, the tunnel is confirmed through use of an email address. Only one email
address can be used for one tunnel and may not be applied to another tunnel.These settings must match the
Remote Group Setup on the other end of the tunnel.
Remote Security Group Type. Select the local LAN user(s) that can use this VPN tunnel. Remote Security Group
Type may be a single IP address, a Subnet or an IP address range. The Remote Secure Group must match the
Local Secure Group on the other end of the tunnel. Selecting IP Address allows only one computer, with the
specific IP Address, access to the tunnel. (The default IP is 192.168.1.0.) If you select Subnet, all computers on
the local subnet can access the tunnel. The default IP is 192.168.1.0, and default Subnet Mask is
255.255.255.192. If you select IP Range, you can specify a range of IP Addresses to access the tunnel. The
default IP Range is 192.168.1.0~254.
With Group VPN enabled:
Further Remote Client Setup options become available when you select GroupVPN. There are three types of
Remote Client: Domain Name (FQDN), E-mail Address (User FQDN), and Microsoft XP/2000 VPN Client.