Lynx Professional Grills 27" Free Standing Grill L27PSR-2 - Manual (Page 31)

31
UNpACKING ANd ASSEMBLY
the grill arrives nearly ready
to use and requires only minor
assembly.
By carefully following the
uncrating and unpacking
steps, you will improve the
customer’s first Lynx experi-
ence.
shipping weight on smaller
units is app. 300 pounds and
larger units may weigh over
500 pounds.
crate & carton:
► Important!
do not remove staples
around the top of the
carton. these staples
hold a wooden pallet in
place inside the carton
that protects the unit from
damage. Removing these
staples may cause the
pallet to fall on the top of
grill.
How to remove
the carton
► cut the main strap holding
the grill to the pallet.
► Remove the staples at the
bottom of the carton.
► lift off the carton.
► with assistance, remove
the grill from the pallet and
place into desired location.
warning
EXCESSIVE WEIGHT HAZARD!
Use two or more people to
move or install this unit. Fail-
ure to follow this instruction
can result in back or other
personal injuries.
the wheels sit down in the
gaps of the shipping crate so
that the grill can sit safely and
solidly on the crate during
shipping. the grill cannot be
slid directly off of the pallet.
one way to safely move the
grill off of the pallet is by
lifting one end of the grill
high enough to place a ramp
under the wheel and then lift
the other end while rolling the
grill off of the pallet.
InterIor pacKIng
lynx uses sturdy tie-down
cables and straps to ensure
your grill arrives at your home
in the same condition that
it left our factory. Be suRe
you haVe RemoVed all
tie downs BefoRe using
youR gRill.
► Remove the white
accessory box and wood
packing, the grill racks, and
remove any loose items
from the firebox.
► carefully cut the cable
ties securing the warming
Grill will not slide directly off pallet.
rack and rotisserie spit (if
equipped).
► cut the strapping that
secures the briquette trays
and carefully lift them out,
front first.
make sure you remember to
remove the wire tie-downs on
the burners
► on prosear™ 2 models,
cut and remove ties from
the burner partition on the
left side of the prosear™ 2
burner.
► ensure that all burners are
properly seated on the
burner valve orifice and
sitting level with the legs
in the frame slots and no
side-to-side movement.