Lynx Professional Grills 27" Free Standing Grill L27PSR-2 - Manual (Page 20)

20
grIll Won’t lIgHt
First, confirm that the grill is
getting electricity by turning
on the lights, then:
► checK the igniteRs
your lynx grill uses an electric
ignition system that does not
spark. instead, the igniters
should glow constantly when
a control knob is pushed in.
ensure that all burner
controls are set to off.
Remove the cooking
grates and briquette trays.
watch an igniter as you
push in and hold the cor-
responding control knob.
you will need either a
small mirror or shiny metal
object to see the igniter
under its cover.
(Be sure you push in the
correct control knob and
keep the knob in the
“off” position)
check the remaining
igniters. if igniters don’t
glow, proceed with trou-
bleshooting or match-
light the burner.
► checK the BuRneRs
if the igniters are working
check to see if gas is
reaching the burners by at-
tempting to match light a
burner.
Be caReful! if the
BuRneR fails to ignite,
wait 5 minutes BefoRe
attempting to ignite
otheR BuRneRs! (see
indeX: “match lighting” for
further details.)
smell of gas
WHIle cooKIng
if you smell gas while
the gRill is opeRating,
immediately tuRn off all
BuRneRs and shut off
the main fuel supply.
► peRfoRm a leaK test
(see indeX: “leak test” for
further details.)
► checK foR BlocKages
(see indeX: “clean the Brass
Burner” for further details.)
pOTENTIAL pROBLEMS
if match lighting doesn’t work,
re-check fuel connections for
leaks and ensure the supply
is of the correct type and is of
adequate pressure. (see indeX:
“leak test” for further details.)
if the burner will light with a
match, then the igniter may
not be functioning correctly.
call for service.
if the burner will not match
light, and you know you are
getting gas, wait for any
gas to dissipate and remove
the burner and check it for
blockages. (see indeX: “clean
the Brass Burner” for further details.)
gas collector hood
hot
surface
igniter