Lynx Professional Grills 27" Free Standing Grill L27PSR-2 - Manual (Page 22)

22
burner goes out
► location
first determine if the problem
is being caused by location.
if the grill is subject to high
winds, reposition it to provide
some protection.
► checK the flame
check the gas supply and
flame characteristics. (see
indeX: “flame, correct size”)
► BuRneRs seated
check to ensure that the
burners are correctly posi-
tioned in the grill. (see indeX:
“Burner placement” for further
details.)
correctly-installed burners
should be seated firmly and
level with no side-to-side
movement.
burner goes out
only WHen set to
“loW”
the valves on the grill feature
an adjustable low setting.
fluctuations in gas pressure,
gas conversion and even in
the quality of the gas itself
may affect burner perfor-
mance at the “low” setting.
it could be either too high or
too low. (see indeX: “Burner
adjustment” for further details.)
rotIsserIe
Won’t lIgHt
follow the same procedure as
described for the grill burners
to diagnose problems with the
rotisserie burner.
Be caReful! the rotisserie
burner flame may be hard to
see in bright sunny conditions.
rotIsserIe lIgHts
but goes out as
soon as control
Is released
► checK
theRmocouple
the control knob must be
held in for 30 to 60 seconds
after ignition for the rotis-
serie burner to stay lit. (see
indeX: “lighting the rotisserie”
for further details.)
if the burner will not stay lit
when you release the control
knob, re-light it and hold the
control knob in for at least
60 seconds to allow the ther-
mocouple to heat up.
if, after holding the control
knob in for at least 60
seconds, the burner still will
not stay lit when releasing
the control knob, call for
service.
(see indeX: “obtaining service
from lynx” for further details.)
lIgHts Won’t lIgHt
► checK poweR
ensure that the grill is
connected to a live ac
power source and check for
rotisserie motor operation.
► Reset tRansfoRmeR
disconnect power from the
grill and wait 5 minutes for
the transformer to cool down
and reset. then reconnect
power. if, after resetting the
transformer and replacing
bulbs, you still do not have
power, call for service.
► Replace the BulB
Replacement bulbs are
halogen, 12 volt, 10w
max, t3 type with a
g4 bi-pin base.
the glass cover is held in
place by two spring tension
tabs. you may have to loosen
the screw to remove the lens.
avoid touching the glass of a
new bulb. halogen bulbs are
very sensitive to the oils found
in human skin. touching the
bulbs may shorten their life.
pull the bulb straight out from
the socket without twisting.
the 27” and 30”grills each
have one halogen light fixture;
all other grills have two light
fixtures.
hold the bulb using a paper
towel or other cloth and
gently press it straight into the
socket. the glass cover should
be gently snapped back into
place.
pull on
sprIng
tabs to
release
lIgHt
cover