Lifescan SureStep blood glucose monitoring system - Manual (Page 63)

55
If you wish to change the unit of
measurement to mmol/L, press the
C button. This symbol will flash on
the display.
Then, wait for the next feature set-
ting (beep signals) to appear.
Beep Signals
The SURESTEP ® Blood Glucose
Meter uses beeping tones to
signal various steps in the meter
procedures. However, these tones
do not indicate that the procedures
are being performed correctly. The
meter is pre-set to emit three differ-
ent beep signals:
1. A single short beep signals each
step in the test procedure.
2. A single long beep accompanies
error messages, a “ ” result, and
certain mistakes in doing the test
procedure.
3. A three-tone beep sounds when
the meter displays a test result
and when the meter is in set-up
mode on the beep signal feature.
SETTINGS
LSI-98-090 SS booklet.B 7/13/98 11:41 AM Page 55