Linksys ProConnect SVIEW08 v2 - Manual (Page 13)

In order to prevent unauthorized access to the PCs, the OSD provides a pass-
word security feature. If a password has been set, the OSD will request that the
user provide it before allowing access.
To set a password:
1. Press the F6 key to bring up the setup configuration menu.
2. Move the Highlight bar to Set Password and press the Enter key.
3. Type in the new password and press the Enter key. (The password may be
up to eight alphanumeric characters in length.)
4. Type in the new password again in order to confirm that it is correct and
press the Enter key. If the two entries do not match, an error message will
display, reading “PASSWORD NOT MATCH”. If this occurs, input your
password again.
To modify or delete a password:
1. Press the F6 key to bring up the setup configuration menu.
2. Move the Highlight bar to Set Password and press the Enter key.
3. To Delete the Password: Delete the password and press the Enter key
To Modify the Password, Delete the previous password and type in the
new password and press the Enter key.
4. Type in the new password again in order to confirm that it is correct and
press the Enter key. If the two entries do not match, an error message will
display, reading “PASSWORD NOT MATCH”. If this occurs, input your
password again.
OSD Security
20
* If a password has been set, you must supply the password to access these
functions.
FACTORY DEFAULT SETTINGS
SETTING FUNCTION
Lock Console*
Clear the Name
List*
Locks/Unlocks the Console. When the Console is
locked, only the current PC will be displayed on
the monitor but no input will be allowed, nor will
you be able to switch to a different port. The only
way to regain access to the PCs is by Unlocking
the Console. If a password is set, that will need
to be entered to Lock/Unlock the Console. If no
password has been set, pressing the [Enter] key
will Lock/Unlock the Console.
Clears all Port Names from the Name list. You
are asked to confirm before completing the pro-
cedure. Type “Y” and then press the [Enter] key
to confirm. A message will appear on the display
to indicate when the names have cleared.
Restore Default
Values* Clears all settings from memory and returns the
unit to the factory defaults. You are asked to
confirm before completing the procedure. Type
“Y” and then press the [Enter] key to confirm. A
message will appear on the display to indicate
when the names have cleared.
SETTING
Display Duration
Display Mode
Scan Duration
DEFAULT
Always On.
The Port Number plus the Port Name.
3 Seconds.
21
ProConnect ® Series ProConnect ® 8-Station KVM Switch