Applying settings, Applying factory defaults – Lantronix 900-422 User Manual
Page 43
5: Configuration Using Web-Manager
XPress DR+ User Guide
43
Endpoint Configuration
Local Port
Enter the local port number.
Remote Port
Enter the port number of the remote device.
Remote Host
Enter the IP address of the remote device.
Device Address Table
The table is enabled when Datagram Type is set to FD. Enter
values between 1 and 255 to identify units on the local
network of device servers.
Note:
Lantronix Tech Support supports Datagram type 01.
Datagram Type FD is for OEM use.
3. When you are finished, click the OK button.
4. To save and reboot, click Apply Settings on the main menu.
Applying Settings
1. To save and apply the configuration changes to the device server, click the Apply
Settings button.
Note:
Clicking OK on each page does not change the configuration on the
device. OK tells the XPress DR+ what changes to use; Apply Settings
makes the changes permanent and reboots the XPress DR+.
Applying Factory Defaults
1. Click
the
Apply Defaults button to set the device server back to the default settings.
For details see
2. Click
Yes to set factory settings, or click No to cancel.