Configuration using web-manager, Accessing xpress dr+ using deviceinstaller, Configuration using web- manager – Lantronix 900-422 User Manual
Page 30
XPress DR+ User Guide
30
5: Configuration Using Web-Manager
You must configure the unit so that it can communicate on a network with your serial
device. For example, you must set the way the unit will respond to serial and network
traffic, how it will handle serial packets, and when to start or close a connection.
The unit’s configuration is stored in nonvolatile memory and is retained without power.
You can change the configuration at any time. The unit performs a reset after you change
and store the configuration.
In this chapter, we describe how to configure the XPress DR+ using Web-Manager,
Lantronix’s browser-based configuration tool. (For information on using Setup Mode, our
command line configuration interface, see
6: Configuration Using Telnet or Serial Port
Notes:
The examples in this section show a typical device. Your device may have
different configuration options.
For the latest firmware, release notes, and user documentation, go to the
Lantronix we
Accessing XPress DR+ Using DeviceInstaller
Note:
Make note of the hardware (MAC) address. You will need it to locate the
XPress DR+ using DeviceInstaller. (For more information on the hardware
address, see
Follow the instructions on the product CD to install and run DeviceInstaller.
1. Click
StartÆPrograms Æ LantronixÆDeviceInstallerÆDeviceInstaller. If the PC
has more than one network adapter, a message displays requesting the selection of
a network adapter. Select an adapter and click OK.
2. Click
the
Search icon
. The list of Lantronix device servers displays in the left
pane.
3. Click on the XPress DR+ folder. The list of available XPress DR+ units displays.
4. Expand the list of XPress DR+ units by clicking the + symbol next to the XPress DR+
icon.
5. Select the XPress DR+ unit by clicking its hardware address.
6. In the right pane, click the Web Configuration tab.
7. To view the unit's Web-Manager in the current DeviceInstaller window, click the Go
button.