Lincoln Electric Stick Electrode Welding C2.410 - Manual (Page 19)

-19-
When welding with High Speed electrodes (E6012 and E6013)
deposit the entire weld in one pass using non-weave beads or a
slight weave. Drag the electrode on the joint and stay ahead of
the molten pool. Use enough drag angle so the arc force pushes
the weld metal back. Use currents in the high portion of the elec-
trode’s range.
When welding with Out-Of-Position electrodes (E6010 and
E6011), deposit the entire weld in one pass using non-weave
beads or a slight weave. Hold a 1/8” or shorter arc. Move as
fast as possible while maintaining good fusion. Use currents in
the middle of the electrode’s range.
Weld overhead joints using E6010 or E6011 electrodes with a
whip technique and a slight circular motion in the crater. Do not
weave. Point the electrode directly into the joint and slightly for-
ward into the direction of travel. Use a fairly short arc and travel
fast enough to avoid spilling. Use currents in the lower portion
of the electrode’s range. Overhead welding of 18 gauge and
thinner is not recommended.