K8sli, Onboard fdc controller, Onboard serial port – Lok8u K8SLI User Manual

Page 41: Onboard parallel port, Parallel port mode, Epp mode select, Ecp mode use dma, Pwron after pwr-fail

K8SLI

Onboard FDC Controller

Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”.
Options: Enabled (default)、Disabled

Onboard Serial Port

Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled、3F8/IRQ4 (default for port1)、2F8/IRQ3(default for port2)、3E8/IRQ4、
2E8/IRQ3、Auto

Onboard Parallel Port

Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)、278/IRQ5、3BC/IRQ7、Disabled

Parallel Port Mode

This option allows you to select a parallel port mode for the onboard parallel port.
Options: ECP(default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal

EPP Mode Select

Select EPP port type 1.7 or 1.9. This field is only configurable if “Parallel Port Mode” is set to “EPP”
or “ECP+EPP”. Options: EPP 1.9(default)、EPP 1.7

ECP Mode Use DMA

Select a DMA Channel for the parallel port when using the ECP mode. This field is only
configurable if “Parallel Port Mode” is set to “ECP”. Options: 3 (default)、1

PWRON After PWR-Fail

This field will determine whether your system will boot after restoring power after a power failure. If
you select “On”, the system will boot whether or not the system was on before power failure. If you
select “Former-Sts”, the system will be restored to the status before the power failure.
Options: Off (default)、On、Former-Sts