Lok8u K8SLI - Manual (Page 35)

K8SLI
29
RAS# to CAS# delay (Trcd)
Select the DRAM delay time when being read.
Options: Auto、2T、3T、4T、5T、6T、7T
Row precharge Time (Trp)
You can set the time to precharge. Options: Auto、2T、3T、4T、5T、6T、7T
1T/2T Memory Timing
Use this item to select the memory timing that you installed.
Options: 1T、2T(default)
System BIOS Cacheable
When enabled, accesses to system BIOS ROM addressed at F0000H-FFFFFH are cached, provided
that the cache controller is enabled. Options: Enabled、Disabled (default)
PnP/PCI Configurations
Reset Configuration Data
Select “Enabled” to reset the Extended System Configuration Data (ESCD) if you have installed a
new add-on card and the system reconfiguration has caused such a serious conflict that the OS cannot
boot. Options: Disabled (default)、Enabled
Resources Controlled By
BIOS can automatically configure all the boot and Plug and Play compatible devices. If you choose
Auto, you will not be able to manually assign IRQ DMA and memory base address fields, since
BIOS automatically assigns them. Options: Auto (default)、Manual
IRQ Resources
When resources are controlled manually, you can assign each system interrupt a type, depending on
the type of device using the interrupt. This is only configurable when “Resources Controlled By” is
set to “Manual”.
IRQ-3 assigned to: PCI device
IRQ-4 assigned to: PCI device
IRQ-5 assigned to: PCI device
IRQ-7 assigned to: PCI device
IRQ-9 assigned to: PCI device
IRQ-10 assigned to: PCI device
IRQ-11 assigned to: PCI device
IRQ-12 assigned to: PCI device
IRQ-14 assigned to: PCI device
IRQ-15 assigned to: PCI device