Lok8u K8SLI - Manual (Page 23)

K8SLI
17
ABS (Albatron BIOS security) Header: BIOSCN1
This mainboard includes one ABS header (BIOSCN1) for the ABS card which can provide a second
BIOS for the mainboard in case the original BIOS is damaged. To set up the jumper on the ABS card,
please refer to figure1. (Attention: Whether you want to use this function or not, removing this
jumper cap from the ABS card is interdictory.)
Attention: There are two jumper caps on the ABS header (BIOSCN1).
One is in pin1 -2, and the other is in pin3 -4. Before installing the ABS
card, remember to remove these jumper caps first. But, if you don’t
want to use the ABS card, please DO NOT change the positions of the
jumper caps and DO NOT remove them. Otherwise, the mainboard
and the ABS card might become damaged.